RE: [Repeater-Builder] 600 - 10k ohm Interface

[Steve Bosshard \(NU5D\)]

Terminate the 600 Ohm output with a 680 or 570 Ohm resistor then connect to the controller..  This will make the source happy.  If it overdrives the controller, add a 4.7K to 10K ohm resistor in series to swamp the input to taste..  I am making an assumption that the controller and the receiver are in close proximity and that line balance is not an issue and isolation is not needed.   Ssb     ·         From: Richard W. Solomon [mailto:[EMAIL PROTECTED] Sent: Sunday, December 12, 2004 6:47 PM    Yahoo! Groups Links To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/   To unsubscribe from this group, send an email to: [EMAIL PROTECTED]   Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. --- Incoming mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.809 / Virus Database: 551 - Release Date: 12/9/2004 --- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.809 / Virus Database: 551 - Release Date: 12/9/2004