The TP-38 only displays what tones are programmed to be enabled for decoding. There is a keypad command to step through and display all active tones that are enabled. Refer to the manual to validate your programming
Ron Rogers WW8RR -----Original Message----- From: skipp025 [mailto:[EMAIL PROTECTED] Sent: Tuesday, February 22, 2005 1:49 PM To: [email protected] Subject: [Repeater-Builder] Re: Comm Spec TP-38 Does the tone panel even display frequencies above 100Hz, just not decode them? That's a software problem or programing. Most other problems are hardware related. Just running a test sub tone in from an external source will tell you mucho. skipp > "Brent" <[EMAIL PROTECTED]> wrote: > Question... > > Has anybody had a problem with the Communications Specialists TP-38 Tone > Panel not decoding PL tones about 100.0hz > it decodes from below 100.0 just fine and 100.0 but 100.0 is little slow > decoding but above 100.0 it just does nothing.. > > Thanks > Brent > > > > > > > > > -- > No virus found in this outgoing message. > Checked by AVG Anti-Virus. > Version: 7.0.300 / Virus Database: 266.2.0 - Release Date: 2/21/2005 > > --- > [This E-mail scanned for viruses at TNWEB LLC] Yahoo! Groups Links Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
