Vern, The RC-1000V does turn on/off DTMF decoder audio based on COS. So if not getting COS the rx audio will not get to DTMF decoder.
>From your later posting I replied to I think you are not getting good COS from >Mastr II. 73, ron, n9ee/r >From: [EMAIL PROTECTED] >Date: 2007/07/10 Tue PM 05:19:39 CDT >To: [email protected] >Subject: Re: [Repeater-Builder] GE MASTR II and RC-1000V > >Yes it's not bringing the repeater up on a reliable basis. > I have left the radio keyed up for at least 30 seconds >and it still won't bring up the repeater. > >I don't think the DTMF codes are getting through either so >I can't change the anit-kerchunk. Should the repeater be >keying up when I enter DTMF codes? I know it mutes them >but should it still go into transmit? > >On Tue, 10 Jul 2007 17:09:38 -0500 (CDT) > Ron Wright <[EMAIL PROTECTED]> wrote: >> Vern, >> >> One question. What do you mean "hard time kicking into >>transmit mode"??? >> >> Are you refering to having to give strong signal into >>the repeater or long key into the repeater to bring up??? >> >> The RC-1000V has a anti-kerchunk filter that requires a >>time delay before it keys the repeater. This can be >>turned on and off. >> >> Might be more specific on the problem. >> >> 73, ron, n9ee/r >> >> >> >> >> >> >>>From: mung_bungholio <[EMAIL PROTECTED]> >>>Date: 2007/07/10 Tue AM 10:21:31 CDT >>>To: [email protected] >>>Subject: [Repeater-Builder] GE MASTR II and RC-1000V >> >>> >>>I purchased a GE MASTR II with an RC-1000V controller and >>>I am having a >>>problem with it. >>> >>>When I power it on it transmits the ID and seems to be >>>functioning like >>>it should. However once on it has a hard time kicking >>>into transmit >>>mode. I think that it may be that the radio is not >>>breaking squelch. >>>I have no idea how this was setup and modified so it may >>>just be that >>>the squelch circuit is not right or not adjusted right, >>>however I have >>>not seen any squelch adjustment at all on the outside of >>>the radio. >>>Before I start to tear this thing apart and break >>>anything that isn't >>>already broken. Is there any way I can determine if the >>>radio is >>>breaking squelch or what is going on with receive? >>> >>>All I have is the control cable with the end cut off >>>which is patched >>>into a terminal strip that is then connected to the >>>RC-1000V cable that >>>goes to the DB25 on the back of the case. Does anyone >>>have the wiring >>>colors of the MASTR II control cable and/or the RC-1000V >>>factory cable >>>if there is such a thing? That might help in trouble >>>shooting. >>> >>>Thanks, >>>Vern >>>KI4ONW >>> >>> >> >> >> Ron Wright, N9EE >> 727-376-6575 >> MICRO COMPUTER CONCEPTS >> Owner 146.64 repeater Tampa Bay, FL >> No tone, all are welcome. >> >> > > Ron Wright, N9EE 727-376-6575 MICRO COMPUTER CONCEPTS Owner 146.64 repeater Tampa Bay, FL No tone, all are welcome.
