At 10:39 AM 1/15/2009, Juan Tellez wrote:
This info I found somewhere in the net, have not tried yet, hope
this helps in your project.
"This Repeater is in use, with easy Programmable IRLP mods made for
TX PL on RX PL. Program any pin but one's below for TOR, state
active high Program pin 24 for PL encode on, and pin 25 for PL
encode off, set the state of pin 24 for high and pin 25 for low, 2
jumpers needed from the TOR pin to pins 24 and 25 now repeater will
only encode while it decodes, and will drop encode when user unkeys."
<----That's just plain silly. There is absolutely no need to program
Aux In/Outs for both logic state. All it takes is one programmed as
an output and one programmed as an input.
Ken
------------------------------------------------------------------------------
President and CTO - Arcom Communications
Makers of repeater controllers and accessories.
http://www.arcomcontrollers.com/
Authorized Dealers for Kenwood and Telewave and
we offer complete repeater packages!
AH6LE/R - IRLP Node 3000
http://www.irlp.net
"We don't just make 'em. We use 'em!"
