--- In [email protected], "w4sef" <w4...@...> wrote:
>Does your Mastr II have the wiring harness for the Mastr II encode board that
>is adjacent to the exciter. iF so I had the same issue with the P & S
>controller. After some time I found the solution. Let me know. JM
> Hi all,
>
> I am new at the GE Mastr II game....Is there a point on the receiver board
> where I can tap off to get an S meter reading? I would like to be able to
> monitor the signal incoming. Also, be able to see if there is any rise in
> meter reading with no signal coming in to check for desense with the transmit
> on and off. I had a Micor and knew where to tap the second limiter for a
> meter reading on signals but can not find the right place on the Mastr II.
>
> Also, I am using the Pion Controller board. I love the controller but I can
> NOT get it to transmit the CTCSS tone. I have tried every setting I can think
> of using the computer to program it but no luck. It will DECODE fine but will
> NOT send the tone! Any ideas?
>
> Thanks
> Steve W4SEF
>
