OK Jim, THANK YOU for that info! Which pin on the black socket? 73s Steve W4SEF
--- In [email protected], Jim Brown <w5...@...> wrote: > > The first limiter is available on a GE Mastr II on the test socket, and can > be used for signal strength after a signal is well above the noise. Lots of > signals can be copied full quieting before the first limiter starts to show a > reading. > > On the P & S controller, you have to hook up to the CTCSS input on the GE > exciter board to get the signal from the controller into the system. Look > closely at the instructions from P & S to see what connections have to be > added. Just plugging the controller in does not get the CTCSS signal to the > exciter. > > 73 - Jim W5ZIT > > --- On Sat, 5/9/09, w4sef <w4...@...> wrote: > From: w4sef <w4...@...> > Subject: [Repeater-Builder] Two questions > To: [email protected] > Date: Saturday, May 9, 2009, 11:40 AM > > > > > > > > > > > > > > > > > > Hi all, > > > > I am new at the GE Mastr II game....Is there a point on the receiver board > where I can tap off to get an S meter reading? I would like to be able to > monitor the signal incoming. Also, be able to see if there is any rise in > meter reading with no signal coming in to check for desense with the transmit > on and off. I had a Micor and knew where to tap the second limiter for a > meter reading on signals but can not find the right place on the Mastr II. > > > > Also, I am using the Pion Controller board. I love the controller but I can > NOT get it to transmit the CTCSS tone. I have tried every setting I can think > of using the computer to program it but no luck. It will DECODE fine but will > NOT send the tone! Any ideas? > > > > Thanks > > Steve W4SEF >
