--- In [email protected], Jim Brown <w5...@...> wrote:
>
> The first limiter is available on a GE Mastr II on the test socket, and can
> be used for signal strength after a signal is well above the noise. Lots of
> signals can be copied full quieting before the first limiter starts to show a
> reading.
>
> On the P & S controller, you have to hook up to the CTCSS input on the GE
> exciter board to get the signal from the controller into the system. Look
> closely at the instructions from P & S to see what connections have to be
> added. Just plugging the controller in does not get the CTCSS signal to the
> exciter.
>
> 73 - Jim W5ZIT
>
> --- On Sat, 5/9/09, w4sef <w4...@...> wrote:
> From: w4sef <w4...@...>
> Subject: [Repeater-Builder] Two questions
> To: [email protected]
> Date: Saturday, May 9, 2009, 11:40 AM
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
> Hi all,
>
>
>
> I am new at the GE Mastr II game....Is there a point on the receiver board
> where I can tap off to get an S meter reading? I would like to be able to
> monitor the signal incoming. Also, be able to see if there is any rise in
> meter reading with no signal coming in to check for desense with the transmit
> on and off. I had a Micor and knew where to tap the second limiter for a
> meter reading on signals but can not find the right place on the Mastr II.
>
>
>
> Also, I am using the Pion Controller board. I love the controller but I can
> NOT get it to transmit the CTCSS tone. I have tried every setting I can think
> of using the computer to program it but no luck. It will DECODE fine but will
> NOT send the tone! Any ideas?
>
>
>
> Thanks
>
> Steve W4SEF
>
