DCFlux, Comments are added to your text below. Thanks for the suggestions.
John -----Original Message-----***[with portions deleted] From: On Behalf Of DCFluX Sent: Saturday, November 07, 2009 5:46 PM Subject: Re: [Repeater-Builder] LDG Voter RVS-8 Mystery TP11 - TP19 should show +6 Volts when measured with a voltmeter on the DC setting. If not check that R8 and R9 are the correct value. ***[I'll check this when I can get back to the repeater.] If that wasn't the problem, I'd try desoldering a pot and measure it with a meter out side the voter. ***[Seems like the right thing to do. Since the component is the suspected culprit, why not check the component directly? Good advice.] Have you looked with an oscilloscope to see if there is anything else riding on the line? This behavior is not common to the LDG voter, so I'd thing there is something weird happening as well. ***[I haven't checked with an oscilloscope, but I can. With AC coupling everywhere I didn't think this could be the problem.] Kevin ***[Thanks, John] __________ NOD32 4582 (20091107) Information __________ This message was checked by NOD32 antivirus system. http://www.eset.com
