Go to: Start Control Panels System Device Manager
Verify that your Com 1 and/or Com 2 are present under the 'Ports' drop down tab. If Com 1 is present, click it, and click Properties (Or right click it then drop down to Properties). Again, verify that Com 1 is functional and functioning normally. Lets go from there. John Hymes La Rue Communications 10 S. Aurora Street Stockton, CA 95202 http://tinyurl.com/2dtngmn ----- Original Message ----- From: Ross Johnson To: [email protected] Sent: Friday, June 11, 2010 12:36 PM Subject: RE: [Repeater-Builder] kyodo kg108 uhf You know that com port works? Older machines serial ports were poorly or not even buffered sometimes. Also if this is a programming laptop, where you use it to program other radios, make sure none of the other programming software is tying up that com port while the machine is running. Ross kc7rjk -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of kerincom Sent: Friday, June 11, 2010 7:49 AM To: [email protected] Subject: Re: [Repeater-Builder] kyodo kg108 uhf Already done that Thank You, Ian Wells, Kerinvale Comaudio, 3A Murchison Street,Biloela.4715 Ph 0749922449 or 0409159932 or 0749922574 www.kerinvalecomaudio.com.au -------Original Message------- From: wd8chl Date: 06/11/10 23:30:03 To: [email protected] Subject: Re: [Repeater-Builder] kyodo kg108 uhf On 6/11/2010 7:45 AM, kerincom wrote: > > > Hi guys .I have the genuine software and programming cable and kg108 uhf > radios and I am trying to read and program them .The software is installed > on a Toshiba 700mhnz laptop running win98se .and when I try to communicate > with the radio it comes up with error in communications .I have tried > running it in dos and still the same .It seems to be a com error because I > have 2 programming cables and the get the same result with both.Can anyone > suggest anything I'm not familiar with those, but chances are if they are more than 6-8 years old, the software is DOS, and Windows won't allow control of the RS-232 port the way it wants. Hit the 'Start' button, and in the shutdown menu, one selection will be "Restart in MS-DOS mode." Select that, and it will take you to a true DOS environment. You'll have to navigate back to the directory you have your program in from there using DOS commands. Jim
