On 2008-05-26, Troels Arvin <[EMAIL PROTECTED]> wrote:
>
> I've tried a handful of different configurations without luck. Some of
> them are stated here:
> http://troels.arvin.dk/san/ds4800/
I'm a bit late in the discussion (been too busy), but.. Could you
draw your SAN connections? Can HBA1 see both DS4800 controllers,
or only one?
My config is:
HBA1 ---> Zone1 ---> DS4800 controller A
HBA2 ---> Zone2 ---> DS4800 controller B
I believe it's important that each HBA only can see one of
the controllers.. At least with RDAC there were problems if
a HBA could see both.
-jf
_______________________________________________
rhelv5-list mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/rhelv5-list
