Adding the rate to the asound does not work. We have had to do that with these sound adapters to make them work. With the new version of Rivendell that does not work anymore. And to be honest it may be something else that was updated. I think Jack is my solution. But I have tried to understand Jack. But it seems pretty complicated.
On Thursday, July 13, 2017, Lorne Tyndale <[email protected]> wrote: > You can always try running it through Jack. > > The other option is to add the rate line into your /etc/asound.conf file > to try and force the card to 44100 > > I've had situations where either / both of the above have worked for me. > > Lorne Tyndale > > > >> >> I would like to try but not sure I can identify what needs rolled back. >> Sounds like I need to wipe the drive and start over. >> >> On Thursday, July 13, 2017, Steve Varholy <[email protected]> wrote: >> > I had a similar issue with my appliance. The upgrade of the appliance >> caused an update to the driver for the built-in soundcard. The updated >> driver no longer supported 44.1. The only way to get it to work was run 48k >> sample rate and everything ran fast/not at all. >> > >> > Ended up getting another soundcard. >> > >> > Can you roll back just the driver? >> > >> > Steve Varholy >> > President and General Manager >> > >> > </mail/u/2/s/?view=att&th=15d3c6d34539a56f&attid=0.3&disp=emb&zw&atsh=1> >> > >> > The Historic Barringer Building >> > >> > 1338 Main Street - Suite 202 >> > >> > Columbia, South Carolina 29201 >> > >> > Office: (803) 753-7260 x 251 >> > >> > Direct: (803) 404-5535 >> > >> > Cell: (703) 585-2101 >> > >> > A Service of the Independent Media Foundation >> > >> > ________________________________ >> > From: [email protected] < >> [email protected]> on behalf of Frank White < >> [email protected]> >> > Sent: Thursday, July 13, 2017 10:45:57 AM >> > To: [email protected] >> > Subject: [RDD] Audio Adapter Issue >> > >> > I am hoping someone on the list can point me in the right direction with >> an audio adapter issue. While trying to make the GPIO system work I needed >> to update to the latest version of Rivendell. I was on 2.5.5. Along with >> the Rivendell update I updated the other software. Now on version 2.16.0. >> Originally loaded the software using the Paravel Appliance Software. I >> have always had to add "rate 44100" to the asound.conf file. But after the >> update the sound adapter would not be recognized by Rivendell. Changed >> System Settings in RDADMIN to 44100 and the adapter shows up again. But >> now the audio will play for about 2 seconds and then sound like white >> noise. Anyone have any ideas? >> > >> > -- >> > Frank White >> > Frank White Technology >> > >> >> -- >> Frank White >> Frank White Technology<hr>_______________________________________________ >> Rivendell-dev mailing list >> [email protected] >> http://caspian.paravelsystems.com/mailman/listinfo/rivendell-dev > -- Frank White Frank White Technology
_______________________________________________ Rivendell-dev mailing list [email protected] http://caspian.paravelsystems.com/mailman/listinfo/rivendell-dev
