So what you say is if I have say five tracks and each has midi commands
configured like youi describe, then if I played one track and then
switch to another, it is not going to send the midi commands
pre-configured for the new track when I play the new one.
?
If I understand you correctly that is the case.
Then I dont even know why these right click midi commands are there as
it is useless as it only executes at program start not when you play a
track.
Do I understand you right?
I need the midi commands sent for a specific track when I play the
track.
On 2020-08-03 07:25, Hugo van Galen wrote:
If you right click on a track you can choose the "Event List Editor".
There you can insert the Program Change or Controller messages that
are specific to your synth to select the correct patch. You obviously
insert these before all the other events.
However, Rosegarden will only send them at the start of the song
though (or rather, at the timestamp configured) -- not when you select
the track. Perhaps that is what you are looking for, though? It is
even possible to change the patch halfway through the song to select a
different instrument.
Hope this helps.
Regards,
Hugo
_______________________________________________
Rosegarden-user mailing list
[email protected] - use the link below to unsubscribe
https://lists.sourceforge.net/lists/listinfo/rosegarden-user
