Greg,
looking back in the doc I found:
Poll (P)
Set to 1 if the local system is sending a Poll Sequence or is a
session of type MultipointHead soliciting the identities of the
tails, or 0 if not.
This looks to me as not being in line with the rest of the document,
especially the part on "MultipointHead soliciting the identities of the
tails".
Am I right in thinking that this anticipates on
draft-ietf-bfd-multipoint-active-tail ?
If so, please clarify this in the doc; if not, please correct me.
Thanks
-m
Le 2018-05-15 à 1:09, Greg Mirsky a écrit :
Hi Michael,
thank you for the most expedient response. Both updates are in the new
working version.
Regards,
Greg
On Mon, May 14, 2018 at 3:58 PM, Michael Richardson
<[email protected] <mailto:[email protected]>> wrote:
Greg Mirsky <[email protected] <mailto:[email protected]>>
wrote:
> The text that follows the first sentence in section 4.13.1 is the
> replacement of the entire section 6.8.6 of RFC 5880. Would
stressing that
> make the relationship more clear, e.g.:
txt> The following procedure replaces the entire section 6.8.6
of [RFC5880].
> And the same can be applied to the first sentence in section
14.3.3:
txt> The following procedure replaces the entire section 6.8.7
of [RFC5880].
That seems like good text.
--
] Never tell me the odds! | ipv6 mesh
networks [
] Michael Richardson, Sandelman Software Works | network
architect [
] [email protected] <mailto:[email protected]>
http://www.sandelman.ca/ | ruby on rails [
