Hi Matthias, the two logs are at https://users.fmi.uni-jena.de/~king/logs/
Best regards, Simon On 2021-08-29, Matthias Köppe <[email protected]> wrote: > Singular vendors a part of gfan called gfanlib. Perhaps an installation of > that is leaking into your build. > > If you can share your top-level config.log and the full gfan build log, we > can take a closer look. > > On Sunday, August 29, 2021 at 11:50:32 AM UTC-7 Simon King wrote: > >> Hi Matthias, >> >> On 2021-08-29, Matthias Köppe <[email protected]> wrote: >> > On Sunday, August 29, 2021 at 5:44:33 AM UTC-7 Dima Pasechnik wrote: >> > >> >> is gfan partially taken from the system? >> >> >> >> probably. Ubuntu 16.04 has gfan version 0.5, but Sage needs 0.6.2. >> >> A system-wide install of old gfan might get in the way. >> > >> > No, that alone cannot explain it -- we test this configuration. >> > ubuntu-xenial-standard installs the system gfan, then rejects it, then >> > correctly builds gfan. >> >> What could explain it? Is there a typical application that I might have >> installed and depends on gfan? I mean, it is for Groebner fans. So, what >> *non-mathematical* software would use it? I don't think that I installed >> a mathematical software after the last successful build of Sage. >> >> Should I try to uninstall gfan, re-install it, and try again? And, >> if that fails, uninstall and NOT re-install, but build Sage and hope >> that it provides a working gfan? >> >> Best regards, >> Simon >> >> > -- You received this message because you are subscribed to the Google Groups "sage-release" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/sage-release/sgh096%24bsr%241%40ciao.gmane.io.
