[beagleboard] Re: Configure Beaglebone to access usb0 from host PC. (Cannot ssh to beaglebone through USB)

Same Issue here. Il giorno venerdì 30 ottobre 2015 18:13:55 UTC+1, Alex ha scritto: > > Hi, > > I am using ubuntu 14.04 (from Robert Nelson ) with a > custom 3.15.10-bone8 kernel on Beaglebone Black. HDMI is disabled. > When I plug the board to a PC, Beaglebone powers up

[beagleboard] BBB for CNC

Hello everyone, I'm trying to build a CNC machine using Beaglobone black. I created a Debian Machinekit Image, but I had this problem when starting LinuxCNC, someone can help me?

Re: [beagleboard] BBB for CNC

On 12/6/2015 11:07 AM, gianldesim...@gmail.com wrote: > > > Hello everyone, I'm trying to build a CNC machine using Beaglobone black. I > created a Debian Machinekit Image, but I

[beagleboard] X11VNC fighting me tooth and nail. Would really appreciate some help.

Greetings, I am trying to install X11VNC and log into it via my laptop and I am having some tough luck Here is what I have done.. I have changed my IP address to a 192.168.1.XX My router for some reason still thinks it is the old IP address even when I refresh it. I have turned on

[beagleboard] Re: eMMc flashing problem. 4 led blinking problem.

I had the same problems Here's what I did 1. They are correct a 5v 2amp power supply is defiantly needed 2. Make sure the image is a eMMC flasher AND is a 2GB for Rev B and below or a 4GB for a rev C (This will cause the load to fail 3. The whole thing should take 45 min MAX so it it's still

[beagleboard] Set priority of network interfaces wlan0 rather than eth0

Hi guys, I am pretty new using a BBB, and I am trying to use it with two network interfaces, one, wlan0 to get internet through usb wifi dongle, two a local connection via eth0 to another network. I configured the /etc/network/interfaces wlan0 as a inet with dhcp, eth0 with inet..

Re: [beagleboard] X11VNC fighting me tooth and nail. Would really appreciate some help.

On 12/06/2015 08:29 PM, Bill Dussault wrote: > I start tightVNC on my laptop > > > 192.168.1.XX:5901 > You could try port 5900 instead of 5901 and look into the x11vnc logfile to confirm that your vnc client is connecting. Nuno -- -- For more options, visit

[beagleboard] Bulk flashing of BBB eMMC

What is the quickest way to bulk flash say 10 BBB's eMMC? At the moment I have 10 Micro SD Card with a custom flasher image on and this works but wondered if there was a more slick solution out there at all? -- For more options, visit http://beagleboard.org/discuss --- You received this

Re: [beagleboard] Re: Configure Beaglebone to access usb0 from host PC. (Cannot ssh to beaglebone through USB)

You need g_ether.ko module. You can check it is loaded. On Sun, Dec 6, 2015 at 7:44 PM, hllpc wrote: > Same Issue here. > > Il giorno venerdì 30 ottobre 2015 18:13:55 UTC+1, Alex ha scritto: >> >> Hi, >> >> I am using ubuntu 14.04 (from Robert Nelson