[drakelist] T4XC/R4C out of sync

separate PTOs or transceive with the rx PTO all works great.  Is there a trimmer or coil I should tweak to bring the two peaks closer together?? Ive got the Drake manual and Garrys CD.  Thanks in advance. K4GM- George

[drakelist] Replacing cathode resistors

K4GM -George [EMAIL PROTECTED] made an utterance to the drakelist gang -- Hi Garey, I continue to refer to the pix from your Drake CD so your efforts are definitely appreciated. My latest problem is that I have to replace

RE: [drakelist] MN-2000 With Balanced Lines

K4GM-George [EMAIL PROTECTED] made an utterance to the drakelist gang -- I plan to find out this weekend when I hook up my recently acquired MN2000 to a W2AU 4:1 balun which will be connected to my 135 foot all band dipole fed

RE: [drakelist] A question on restoring and improving an AC-4

K4GM-George [EMAIL PROTECTED] made an utterance to the drakelist gang -- Just buy and install the AC-4R sold by WB8VGE. It replaces all parts with solid state parts and bigger and better caps and resistors. I have one

[drakelist] Audio static

K4GM-George [EMAIL PROTECTED] made an utterance to the drakelist gang -- I have a nice R4-C with the following Sherwood mods: AMP-4, FC-4, MIX-4, PD-4, PS-4 and the three filter switch kit. The radio works well especially

[drakelist] T4-XC low output

K4GM-George [EMAIL PROTECTED] made an utterance to the drakelist gang -- Until recently my T4XC PTO output was perfect in that there was no difference in S meter readings on signals when switching from transceive with the R4C

Re: [drakelist] Drake L-4B

I've used a 20 amp line for a couple of years. My L-4B works great. If you do the math (P=EI) at 20 amps you would have capacity for roughly 4800 watts which is at least DOUBLE the AC wattage needed for the L-4B for full RF output. 73, George K4GM Bill wrote: Just bought a Drake L-4B amp

[Drakelist] Dueling L-4Bs

levels for a given output? Would that indicate whether one set of tubes might be better than the other? Any other thoughts about judging the better of the two?? All replies greatly appreciated. K4GM- George ___ Drakelist mailing list Drakelist

[Drakelist] R4C static after Sherwood 3d mixer mod

I have obtained an R4C with many of the Sherwood mods installed including the solid state 3d mixer which is supposed to eliminate the dreaded frying crackle. Unfortunately occasionally I hear a bit of static sounding to me like what a brief solar flare might sound. It is not really a hiss

[Drakelist] L4-B resistor substitute

I have an ailing R12 in my L4-B power supply. Although functioning a portion of the outer cover has split off and I am afraid it is only a matter of time until it fails. The resistor is listed as .82 ohms at 2 watts. There is a note to replace with IRC Type BWH resistor only. I did find a

[Drakelist] No T4XC output

I turned on my trusty T-4XC a little while ago and it failed me! I will try to swap out a tube or two but here are my observations in case anyone might be able to point me to the fix. 1.The PTO appears to work fine because I can use it to operate the R-4C in transceive mode using the xmtr

Re: [Drakelist] need a ac-4

I have a working AC-4 for $100 plus shipping. George K4GM On 4/3/2011 4:48 PM, y...@aol.com wrote: Anyone have a AC-4 supply. Plan to rebuild the supply with heathkit shop board and parts. Will consider all as long as the transformer is good. thanks dale wt4t please contact me off list.

[Drakelist] Need bad FT-243 to use holder as plug

I am setting up a 2NT with a VFO. The easiest way to connect seems to be to connect the output of the vfo to a crystal socket. I would like to try as a plug an FT-243 crystal holder with the crystal removed and the vfo output soldered to the two holder pins. Anybody willing to part with an

[Drakelist] TR4CW/rit

Just got home from Dayton with a TR4CW/rit. Hooked it up and find that the transmitter will put out 150w on cw. All controls seem to act correctly. SO I think I am OK on the transmitter side. The receiver needs some work. I can hear signals but the s meter does not react. The calibrator

[Drakelist] TR4CW/rit

Last night I exercised the RCVR/XCVR slide switch on the side of the radio and it came to life. Seems to work well on 80/40 but 20m is in need of help. The RF Tune is out of range; i.e., the gain on 20m increases as I turn CCW but I hit the end of the range before it peaks. I will align

[Drakelist] Drake 2AQ Q-Mult/speaker F/S

Drake 2AQ for sale. Matches 2B receiver. Works well. Looks good. Pictures available. Price: $150 includes shipping CONUS. George K4GM ___ Drakelist mailing list Drakelist@zerobeat.net http://mailman.zerobeat.net/mailman/listinfo/drakelist