Is there a procedure for reducing the VOX sensitivity in the K2? I have found
nothing in the Manual or in the Menu menu. I am using a Heil Proset. The VOX
triggers when I let a pen drop on the desk . . . I believe I am using the
recommended SSB settings - SSB-A at 2 and SSB-C at 3-1. Any
Is there an established way to have the P3
not read in PEP? I would like to use the
P3's watt meter to tune my amp but the PEP
mode is not good for that.
Thanks,
73,
Gary
KA1J
__
Elecraft mailing list
Home:
Hi,
"Why doesn’t the P3 signal strength agree with the K3S’s S-meter? You would
think the S-meter on the K3S and the signal displayed on the P3 would be the
same. There are several reasons why this might not be the case that have to do
with your display choices.
1.When the K3S
I just checked mine on 40M and when on CW Temp is
bouncing all over the place. Same into a dummy
load as the antenna 300ft away. It also does it
to a lesser extent on 80M and a little bounce on 17M and 10M.
I suspect its in the amp and not related to common mode RF in the coax.
Probably a
Some baluns offer good common mode current rejection while others offer
virtually no common mode rejection. {See DJ0IP site and discussion on
baluns.} Since the feed line from the balun runs down the tower to the
point where the feedline runs underground, that segment of feedline is
exposed
Odds are not good there. The antennas have a balun at the feedpoint,
are on a tower 500 feet from the shack and the hardline runs under
ground. If there is common mode involved, it's some sort of new
hyper-super-ultra-infina-deluxe type never before discovered on earth.
73/jeff/ac0c
From the "Troubleshooting" section of the K3 manual:
*No power output*: You may have routed RF through the KXV3’s XVTR IN/OUT
jacks, either by switching
to a transverter band, or by setting CONFIG:KXV3 to TEST. Also try redoing
TX GAIN cal (pg. 49).
73,
Bob, N6TV
On Tue, Aug 14, 2018 at 9:29
Are you using the PC DATA connector to have the KPA1500 automatically
follow the frequency of your transceiver? If so, try setting MENU:RADIO
POLL OFF; commands from the amp. could be interfering with radio commands
from WSJT-X/OmniRig. You might also try a slower or faster baud rate in
both the
I tried a few BT transmitters. No issue with interference, but the latency
you are concerned about made it impossible to send at any speed. Works fine
on SSB, but for me was not usable for CW and since most of my time is spent
on CW I stopped using it. I know there have been a few members who
I'd say a bit of common mode current on the feed line. I see that
from time to time with my KPA500 on certain bands/antennas.
73
Bob, K4TAX
On 8/17/2018 11:45 PM, Jeff Blaine wrote:
While running the KPA1500 in the SARTG tonight, I noticed that the
temp reading drops about 10C when
I have understood that it is normal that P3 with his extremely narrow IF give
lower S-units that the K3/K3S, but is it possible to adjust the P3 to give
same S-meter readings than my K3S?
Is there any way to give coherent signals intensity both K3 and P3?
On My P3 I read S6 a CW signal that is S9
11 matches
Mail list logo