Re: [Elecraft] FIRST TIME HOOKUP OF N1MM+ TO K3 VIS MICROHAM USB INTERFACE III

Have you followed the instructions in the microHAM USB Interface III Users Manual to set the jumpers for the correct serial signal levels (RS-232 in this case)? After that, look at the configuration example for USB III and N1MM Logger+ which is available in Router (Help | Download Documents) or

[Elecraft] FIRST TIME HOOKUP OF N1MM+ TO K3 VIS MICROHAM USB INTERFACE III

The router software should show if the K3 is connected. Make sure that this works before opening the logging software. Like others have said, use 38400 baud. Carefully follow the MicroHAM instructions. John KK9A N6XI wrote: You got good advice on baud rate. Also, it's wise always to confirm

Re: [Elecraft] FIRST TIME HOOKUP OF N1MM+ TO K3 VIS MICROHAM USB INTERFACE III

Rick, Thanks for advice on Utility. I downloaded and ran but still no joy. I did see FW rev 05.38. I don’t know if that cud be the problem? Greg Best Sent from my iPhone > On Feb 15, 2018, at 9:31 PM, Rick Tavan wrote: > > You got good advice on baud rate. Also, it's wise

Re: [Elecraft] FIRST TIME HOOKUP OF N1MM+ TO K3 VIS MICROHAM USB INTERFACE III

You got good advice on baud rate. Also, it's wise always to confirm proper operation with K3 Utility first. If it doesn't connect, chances are N1MM won't, either. Utility marches through speeds until it finds one that works. MM requires a specific speed setting. 73, /Rick N6XI Rick Tavan

Re: [Elecraft] FIRST TIME HOOKUP OF N1MM+ TO K3 VIS MICROHAM USB INTERFACE III

Yes, I believe the baud rate is the problem. Should be 38400. de VK2HHS On Fri, Feb 16, 2018 at 12:57 PM, Jack Brindle wrote: > A little more info. The K3 and K3S default to 38400 bps on the serial > port. This can be changed in the configuration menu, and you should

Re: [Elecraft] FIRST TIME HOOKUP OF N1MM+ TO K3 VIS MICROHAM USB INTERFACE III

A little more info. The K3 and K3S default to 38400 bps on the serial port. This can be changed in the configuration menu, and you should verify the setting in the menu system. If it is still set to the default, set your PC for 38400 bps (and the MicroHam device as well, then give it a try.

Re: [Elecraft] FIRST TIME HOOKUP OF N1MM+ TO K3 VIS MICROHAM USB INTERFACE III

Try 38400 instead of 4800. Jack, W6FB > On Feb 15, 2018, at 5:33 PM, Greg Best wrote: > > I am trying to get N1MM+ to talk to my K3 but will not do it. > > I am setup for 4800 B, Data 8 bits, Parity N, stop bits 1. DTR and DTS have > been tried with both Always ON

[Elecraft] FIRST TIME HOOKUP OF N1MM+ TO K3 VIS MICROHAM USB INTERFACE III

I am trying to get N1MM+ to talk to my K3 but will not do it. I am setup for 4800 B, Data 8 bits, Parity N, stop bits 1. DTR and DTS have been tried with both Always ON and Always OFF but neither one works. I have tried the Radio reset command from N1MM+ with no luck. Can anyone help? 73¹s