I've just installed the KXV3, which seems to be workingas I can receive
signals through the alternate rx antenna socket.
On Config I get NOR and Test. I don't get 'ON' as the manual indicates.
I have the XV144 with a lead to run from the basic K2 without the
transverter interface. It works
In a recent message, john petters [EMAIL PROTECTED] wrote
...
It would appear, on re-reading the manual this morning, and what has
been said below, that I need a seperate lead from the K3 ACC connector
as the RS232 lead did not work. If that is the case, what do I need to
do with the XV144
Thanks David Roger for the advice. I should be able to sort it out now.
73
John G3YPZ
David Pratt wrote:
In a recent message, john petters [EMAIL PROTECTED] wrote ...
It would appear, on re-reading the manual this morning, and what has
been said below, that I need a seperate lead from the K3
I'd like to make up a K3 Transverter control cable.
Which pins of the Elecraft Transverter J6 DB-9 connector
are connected to which pins of the K3 AUX I/O?
Bud W3LL
[EMAIL PROTECTED]
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You
Bud,
The transverter cable needs only 3 signal lines plus ground.
AUXBUS K3 ACC pin 2 to KXVxx pin 6
KEYING K3 ACC pin 10 to KXVxx pin 9
+12 VDC K3 +12 volts output to KXVxx pin 8 (other methods can be used.
but the KXVxx uses this input to sense when the K3 has been turned on).
Ground
Bud Governale, W3LL wrote:
I'd like to make up a K3 Transverter control cable.
Which pins of the Elecraft Transverter J6 DB-9 connector
are connected to which pins of the K3 AUX I/O?
XV DB9 K3 DB15
PinPin
1 ground5
6 auxbus2
8 XVTR ON
Ian,
Based on information I received from Wayne, I do believe that K3 ACC pin
7 is now dedicated to TX INH. There were complication in sharing it.
If the change is not in the firmware version you are using, it will be
with a forthcoming update. In other words, it cannot be used for XVTR
Don Wilhelm wrote:
Ian,
Based on information I received from Wayne, I do believe that K3 ACC
pin 7 is now dedicated to TX INH. There were complication in sharing
it. If the change is not in the firmware version you are using, it
will be with a forthcoming update. In other words, it cannot
Subject: Re: [Elecraft] K3 Transverter Control Cable
Ian,
Based on information I received from Wayne, I do believe that
K3 ACC pin 7 is now dedicated to TX INH. There were complication
in sharing it. If the change is not in the firmware version you
are using, it will be with a forthcoming
9 matches
Mail list logo
