OK, I figured it out.
There is a confluence of incomplete inventory from Elecraft,
incomplete checking by me, and working late at night after a big meal.
It all comes down to standoffs. I was missing two of the longest ones.
This morning I rethought the problem, and found I had "measured w
ecraft-boun...@mailman.qth.net
> [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Don Wilhelm
> Sent: Monday, December 29, 2008 5:13 AM
> To: Kenneth Lopez
> Cc: elecraft@mailman.qth.net
> Subject: Re: [Elecraft] KRX3 Mounting Problem
>
> Ken,
>
> Measure the standoffs m
Ken,
Measure the standoffs mounted on the main board - they should be 7/8
inch and must have two split lockwashers under them - a total height
above the board not quite an inch. The height of these standoffs are
critical because the 1 1/2 inch screws only engage the threads for about
1/8 inc
email and they will send you the replacement right the way.
cheers,
Johnny Siu VR2XMC
K3# 0046 and many K2s
--- 2008年12月29日 星期一,Kenneth Lopez 寫道﹕
> 寄件人: Kenneth Lopez
> 主題: [Elecraft] KRX3 Mounting Problem
> 收件人: elecraft@mailman.qth.net
> 日期: 2008 12 29 星期一 下午 3:18
> How
Howdy,
I have nearly completed the KRX 3 installation, but have run into a
physical mounting problem
The two 1 1/2" 4-40 screws are not long enough to reach the stand
offs below the KRX3 module
I have VERY carefully followed instructions. There have been some
missing standoffs which I
5 matches
Mail list logo