On 9/3/07, k4zm [EMAIL PROTECTED] wrote:
It sounds like you have the bottom plate mounted 180 degrees out or have not
installed the bail assy. The bottom should be installed so that the bail
assy is located near the front of the K2. Also if mounted 180 degrees out I
don't think you can
JT:
To give you another data point, I just measured my K2 (#5413) and it is
slightly *higher* in the front. With the bail not extended and measuring
from the bottom of the side panels to the tabletop at the front and rear.
Front Clearance ~15/32 in
Rear Clearance ~27/64 in
Both +/- eyeball
JT,
Measure your rear feet. Perhaps you have the wrong ones - but I do not
know of other Elecraft products that use different size feet (although
the K3 may have higher feet).
I just measured 3 K2s with my shop dial caliper. My old SN 20 front
feet measure 0.430 inches and the rear feet
All my friends know the low rider
Seriously.
The front of my newly built K2 looks like a hot rod with dropped
spindles installed. This thing is seriously slammed down in the
weeds. I don't understand it but the rear feet are definitely taller
than the front feet.
How could I possibly screw up
4 matches
Mail list logo