The real problem is that after setting the power to exactly
5.0 watts and holidng TUNE, the power reading on 160 meters only
goes to 1.2 watts; when I tap TUNE to exit, VFO B says: ERR TXG.
Similar problems on other banads, to wit: 1.8 Watts on 80m, 1.4
Watts on 40m, 1.9 Watts on 20m,
: Saturday, December 01, 2007 2:19 PM
To: elecraft@mailman.qth.net
Subject: RE: [Elecraft] K3 Calibration Problem
The real problem is that after setting the power to exactly
5.0 watts and holidng TUNE, the power reading on 160 meters only
goes to 1.2 watts; when I tap TUNE to exit, VFO B says: ERR
I had this problem then I noticed I was out of the US band limits
Try changing frequencies in band and trying again
Simon Lewis
GM4PLM/DL4PLM
http://www.dl4plm.net
-Original Message-
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Sanger, Joseph
Sent: Samstag, 1.
thanks simon ... yeah, I noticed that too ... but still quite low power
on all bands and all frequencies.
-Original Message-
From: Simon Lewis [mailto:[EMAIL PROTECTED]
Sent: Saturday, December 01, 2007 3:04 PM
To: Sanger, Joseph; elecraft@mailman.qth.net
Subject: RE: [Elecraft] K3
I am trying to perform the Ref Oscillator Calibration for my 1 ppm
device:
Method 3 (1 ppm TCXO Option):
* Locate the CONFIG:REF CAL menu entry. Tap 1 to change the name to REF
xxC.
* Locate the calibration data sheet, which shows frequency vs.
temperature over a wide range.
* For each data
PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Sanger, Joseph
Sent: Saturday, 01 December, 2007 13:11
To: elecraft@mailman.qth.net
Subject: RE: [Elecraft] K3 Calibration Problem
I am trying to perform the Ref Oscillator Calibration for my 1 ppm
device:
Method 3 (1 ppm TCXO Option
6 matches
Mail list logo