If you start up the application without the K3 turned on or attached,
you don't need to quit the application to get it to talk to the K3.
Just turn on the K3 (or plug it into the RS232 adapter), then go to
the Port pane and click on the "Test Communications" button. If all is
well the Mac w
I got it solved, David. I don't have internet in my "primitive" shack,
so I had downloaded the software in my house, using K3 Utility. Then I
closed (to sleep) my Powerbook, walked out to the shack, and connected
it to K3. I still had Utility open from before. Apparently, Utility
needs to s
Windy,
> Yes David. all the buttons on the
> CONFIGURATION tab are disabled.
I just did several firmware loads and went directly to the Configuration tab.
All of the buttons were enabled. Next time this happens, try clicking on the
buttons anyway and see if they are still functional even thoug
Yes David. all the buttons on the CONFIGURATION tab are disabled.
Thanks for the instructions on saving CW Terminal Memories. I looked
under HELP/ CW memories but found no advice. Is there some form of
instructions yet?
Windy KM5Q
On Apr 22, 2009, at 3:48 PM, David Fleming wrote:
>
> Hi Wi
Hi Wendy,
> CONFIG tab showed up all buttons in gray, so I was unable
> to save my configurations, etc.
Are you saying that all of the buttons on the Configuration tab are disabled? I
cannot reproduce this.
> TERMINAL tab
> CW Memories -- I typed in a CQ and it transmitted OK. I
> can't fin
5 matches
Mail list logo