Good Evening,
A recycled sunspot is rising for another pass. It rounded the limb
with a bang sending a CME off into space. Hopefully it will continue
its activity and shoot something in our direction. Weather has been very
pleasant. The moist green palette is being replaced by a
"When I powered-up the unit and tapped "HV" I get numbers between 9 and 11
volts (expecting ~ 65 or 70 Volts)."
I'd suggest measuring the actual HV rail at the PA input spade terminal. That
will tell you if you have a real low voltage problem or a voltage sensing
problem. The interlock
Just got a repaired KPA-500 PA/LPF module from Elecraft and installed it
in my KPA-500 Amp. I carefully (I thought) reassembled everything. When
I powered-up the unit and tapped "HV" I get numbers between 9 and 11
volts (expecting ~ 65 or 70 Volts). I know this is not right. I
double-checked
With Don's help and the K3 Utility Program Help file's troubleshooting section,
I got the problem solved. I wasn't panicking but I felt much better after
reloading the files updating the firmware to 5.67.
Turning off the P/S, unplugging the power to the radio and from the radio to
the P3,
John,
You apparently had some glitch in the computer to K3S communications
during the process. Go to the Help file in K3 Utility and look at the
instructions to "Force a Firmware Download" and follow the steps listed
there.
Once you get to the actual firmware download, do not interrupt it
I just tried to update the F/W in my K3S to 5.67 using the Utility (Rev
1.167.25) but it failed. The TX LED is slowly flashing, the display is off,
except for MCU LD.
I couldn't turn off power to the radio with the Power button, so I turned
off the P/S and turned it back on, but no change.
Charly
You also need a rs232 to usb interface, from COM1 on front of remoterig box to
another USB port on the local computer running N1MMLogger
73,
Jorge
CX6VM/CW5W
Enviado desde mi iPhone
El 4 may. 2019, a la(s) 13:50, Charles Tropp escribió:
> Hi,
>
> I recently installed a private
Hi,
I recently installed a private K3-Remote System using my existing K3 and
adding a K3/Ø Mini Control Panel. I have the RRIGSET and all required
cables installed. I have tested the system and it appears to work well as I
can both hear and control the remote radio and send CW on my straight key
Or you could use a threaded through nickel plated brass spacer. Comes in
several lengths… Use a nut driver to tighten.
https://www.mouser.com/datasheet/2/215/452A-1452E-737207.pdf
Sent from Mail for Windows 10
__
Elecraft mailing
Below is another solution. Hurricane wing nut drivers are a possibility.
On small wing nuts I have used a cup hook driver bit. They look like a
"Y".
Wing Nut/Bolt Driver:
I have a K3/0-MINI-F ($699,95 new) plus cable sets RRMINICBL ($59,95
new) and RRMTCBL ($59,95 new) which are surplus to my needs (I had
planned to install a second K3 remote station but will probably not do
anytime soon due to other priorities). All in perfect condition.
Selling the package
11 matches
Mail list logo
