Hi @ll,
a final update to explain what can be done:
use macros and assign these to button PF1 and/or PF2:
PF1 - CWINSSB DELAY;MD3;KS014;BW0240;ML005;MG033;AG040;SWT11;SWT19;
PF2 - CLEANUP
Hi Don,
thanks for your answer and the idea to use macros.
At this time I use KX3 utility to setup a macro for testing.
E.g.:
Macro 2: CWINSSB DELAY;MD3;DELAY;DELAY;KS014;BW0240;SWT11;SWT19;MD2;
Starting mode: SSB: switch to CW, Keyer speed 14, bandwith 2.4kHz, Key MSG
and Key 1... then back to
Martin,
Yes, the CW memories will not work well with CW in SSB.
Input from the paddles or hand key should work fine.
If you must use the CW memories, you must switch to CW mode and set the
frequency above or below the SSB frequency. Perhaps a macro could be
created to do that with one button
Hi Don,
thanks for your answer and Explanation. CW WGHT is known but not helpful
in this case.
I'll try to explan: CW WGHT is set to 800Hz. I'am operating in USB, using
CW-In-SSB. I can answer the station.
But station cannot read my signal, I try to answer with an stored CW Memory
because I am
Martin,
The CW in SSB option already exists in the KX3. Turn to page 37 in the
manual and look at the CW WGHT menu description for how to turn it on
and off.
With it turned on, your CW will be transmitted when touching the paddles
even though the mode is in SSB. Your signal will be heard by
Hi Elecraft,
and also a "high five" to David - met you on "HAM radio 2017" at QRP
project!!
Thanks for your time and the nice discussion.
Now my very special problem I try to post to the "masses" to explain
how to improve transverter work at frequencies from 23cm up to 1.5cm with
KX3.
Hopefully
6 matches
Mail list logo
