On Sep 11 2014 4:03 PM, Gene Heskett wrote:
> On Thursday 11 September 2014 12:00:48 David Armstrong did opine
> And Gene did reply:
>> it's more for Mills than Lathes Gene, but the usual time it takes to
>> change a tool in a toolchanger , then have to
>> re measure because of a broken bit , half
On Thursday 11 September 2014 12:00:48 David Armstrong did opine
And Gene did reply:
> it's more for Mills than Lathes Gene, but the usual time it takes to
> change a tool in a toolchanger , then have to
> re measure because of a broken bit , half way through a job , especialy
> those pcb mills !
it's more for Mills than Lathes Gene, but the usual time it takes to change
a tool in a toolchanger , then have to
re measure because of a broken bit , half way through a job , especialy
those pcb mills !
the number of times iv'e been asked for it , i think it will be worth doing
mostly for commer
On Thursday 11 September 2014 09:56:56 David Armstrong did opine
And Gene did reply:
> yea sure Gene
> ridgid tappng is next on the list
> and auto tool measuing with toolchanger interface
> so it knows when a tool is replaced in the toolchanger to re-measure
> and update tooltable
Humm, I was aut
yea sure Gene
ridgid tappng is next on the list
and auto tool measuing with toolchanger interface
so it knows when a tool is replaced in the toolchanger to re-measure and
update tooltable
problem i have is changing from machine to running gcode and storing
positional info
so it can store position ,
On Thursday 11 September 2014 07:09:16 David Armstrong did opine
And Gene did reply:
> ok Guy's this has me at the moment
>
> i wish to switch a relay at a low speed set by the running gcode S
> value ? ( say 500 rpm)
> i had briefly thrown it at Andy via email and one of his suggestions
> was rem
On 11 September 2014 12:09, David Armstrong wrote:
> i wish to switch a relay at a low speed set by the running gcode S value ?
I must confess that I am a bit surprised that the
motion.spindle-speed-out pin isn't usable.
--
atp
If you can't fix it, you don't own it.
http://www.ifixit.com/Ma
ok Guy's this has me at the moment
i wish to switch a relay at a low speed set by the running gcode S value ?
( say 500 rpm)
i had briefly thrown it at Andy via email and one of his suggestions was
remaping
i had a look at the wiki and the spinde remaping is TBD
i had thought of monitoring the en
