Re: LOAD Problem after POR

2010-03-10 Thread Hal Merritt
, 2010 9:02 AM To: IBM-MAIN@bama.ua.edu Subject: LOAD Problem after POR I got a strange problem when I PORed the z10. There are 10 LPA Hi all, I got a strange problem when I PORed the z10. There are 10 LPARs on channel subsystem 0.  After POR finished, I activated the LPARs and tried to load

Re: LOAD Problem after POR

2010-03-06 Thread Don Williams
To: IBM-MAIN@bama.ua.edu Subject: LOAD Problem after POR I got a strange problem when I PORed the z10. There are 10 LPA Hi all, I got a strange problem when I PORed the z10. There are 10 LPARs on channel subsystem 0.  After POR finished, I activated the LPARs and tried to load the LPARs. .. But I got

Re: LOAD Problem after POR

2010-03-03 Thread Glen Gasior
Correct IOCDS is important, I do not remember if any state of the IOCDS would prevent a LOAD. * Does an activate of the LPAR work ? * Can you access the support element from the HMC ? * I would also check if the IODF dataset is in extents, it must be contiguous. * I imagine you are sev1 with IBM

Re: LOAD Problem after POR

2010-03-03 Thread Ed Finnell
In a message dated 3/3/2010 6:23:44 P.M. Central Standard Time, glen.manages@gmail.com writes: Correct IOCDS is important, I do not remember if any state of the IOCDS would prevent a LOAD. Without a Wait state I'm curious if the migration plan included PSP upgrade to the z10

Re: LOAD Problem after POR

2010-03-01 Thread John Kelly
snip tried to load the LPARs. .. But I got load failed. /snip You didn't indicate if this was your first IPL of the box but it could definitely be hardware. Did you check to see if your IPL device is accessible, eg CHP assigned to LPAR, CUs online, etc. Did you try to IPL a tape, eg, SA dump,

Re: LOAD Problem after POR

2010-03-01 Thread Schwarz, Barry A
When you performed the POR, did you select the correct IOCSDS? -Original Message- From: IBM Mainframe Discussion List [mailto:ibm-m...@bama.ua.edu] On Behalf Of Anson Ye Sent: Saturday, February 27, 2010 6:02 AM To: IBM-MAIN@bama.ua.edu Subject: LOAD Problem after POR I got a strange

LOAD Problem after POR

2010-02-27 Thread Anson Ye
I got a strange problem when I PORed the z10. There are 10 LPA Hi all, I got a strange problem when I PORed the z10. There are 10 LPARs on channel subsystem 0.  After POR finished, I activated the LPARs and tried to load the LPARs. .. But I got load failed. The load message points me to refer

Re: LOAD Problem after POR

2010-02-27 Thread Eric Bielefeld
I suspect you have a hardware problem, or there may be something you are not doing right. In any event, call your hardware service vendor. If you aren't dong something right, they should be able to walk you through it. If it is a hardware problem, the sooner you get them in the better.