On 02:15 PM 5/08/2003, Sanders, Dave said:
I don't understand! There's no mention of InPoly in the PCB Rules and
Constraints Editor.
Can you point me at the relevant KB article. All my searches turn up nothing.
http://www.protel.com.au/resources/kb/default.asp#results
and then search for InPolyg
-Original Message-
From: Ian Wilson [mailto:[EMAIL PROTECTED]
Sent: Tuesday, August 05, 2003 1:02 PM
To: Protel EDA Forum
Subject: Re: [PEDA] Rule confusion
On 01:02 PM 5/08/2003, Sanders, Dave said:
>I need a little help.
>I am using DXP SP2 on a very simple pcb, but I can't
] Rule confusion
On 02:15 PM 5/08/2003, Sanders, Dave said:
>I don't understand! There's no mention of InPoly in the PCB Rules and
>Constraints Editor.
>Can you point me at the relevant KB article. All my searches turn up nothing.
http://www.protel.com.au/resources/kb/default.a
On 01:02 PM 5/08/2003, Sanders, Dave said:
I need a little help.
I am using DXP SP2 on a very simple pcb, but I can't set up the clearance
rules to do what I require.
The general clearance rule is .25mm min between all items.This is fine for
most of the board.
I want to set up a second clearance
I need a little help.
I am using DXP SP2 on a very simple pcb, but I can't set up the clearance rules to do
what I require.
The general clearance rule is .25mm min between all items.This is fine for most of the
board.
I want to set up a second clearance rule that specifies a clearance of .5mm bet
