Joe, Steve, et.al.
Yes, I was engaging Tune prior to clicking "Tx Enable", generally to
make sure the match on my 630M antenna is alright (very narrow
bandwidth) and that output power is correct for 5W EIRP. It is such a
habit that apparently I do it everytime I start WSJT-X!
I restarted WSJT
(Fair warning: I may not be fully awake ...)
I have now reproduced essentially what Eric reported by doing the
following steps:
1. Start WSJT-X in WSPR mode
2. Run a short Tune cycle (click Tune twice)
3. Click Tx Enable
If Step 2 is omitted, I do NOT see what Eric reported. The program
behav
Joe, Eric, Bill,
I can reproduce similar behavior as follows. I am using a TS-480.
Let 0:00 (m:ss) be the beginning of a cycle.
Start the program (i.e. issue the command ./wsjtx) some time after 1:00.
Some time between 1:00 and 1:30, press Tune, then press Tune again.
Some time after 1:30, do Tx
Hi Eric,
On 6/10/2015 6:49 PM, Eric NO3M wrote:
> Having problems with WSPR2 TX here.
>
> WSJTX 1.6.0-devel r5578 (same problems with r5567 also before doing SVN
> update/re-compile)
> Band: 630m
> Tx 1575 Hz
> Tx Pct 33%
> Upload Spots = true
> Band Hopping = false
>
> As soon as I click Tx Enabl
An additional note...
Clicking "Tx Enable" from an off (false) state will start a WSPR2
transmission at any point in time during the current 2-minute cycle (per
status bar "Tx: ."), but only audio is produced if the Tx Enable is
clicked prior to ODD_MIN:30 (ie. 30 seconds into the odd minut
Having problems with WSPR2 TX here.
WSJTX 1.6.0-devel r5578 (same problems with r5567 also before doing SVN
update/re-compile)
Band: 630m
Tx 1575 Hz
Tx Pct 33%
Upload Spots = true
Band Hopping = false
As soon as I click Tx Enable, regardless of how far into a 2-minute
period it is clicked, WSJT
Hi Steve,
I'm happily hopping now with r5533. Seems to be doing the right things...
-- Joe, K1JT
--
___
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https: