Hey guys, Do any of you have much experience reshafting PingEye2's. I have the original BeCu's Square groove and a few years ago had Rifle Lite 5.5's put in them which I am now wanting to change out. I will most likely have a club builder in my area do the reshafting but I wanted to know if these require tapered shafts or parrallel tip. I'm pretty sure they take tapered as microtapers were the original shafts that came out. I am looking at Rifle Lite 4.5's or TT TX-90's in a regular flex depending on how I hit some test clubs in each at my club builders place. Any feedback would be appreciated on this. I've been hitting my irons all over the place and honestly know my swing is not that bad; Not to have only hit 2/18 greens last week when I played. Kinda' hard to break 90 let alone 80 when you seldom hit a green. I will have my swing speed tested when I go see my guy with a 5 iron to better see what shaft will best fit my swing. I was tested at 88-93 with a driver a few weeks ago but not with an iron. Thanks, Mark
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Dave Tutelman Sent: Wednesday, March 19, 2003 10:13 AM To: [EMAIL PROTECTED] Subject: RE: ShopTalk: Straightness finder At 09:53 AM 3/19/03 -0600, you wrote: >I took a couple of 2x8x48" red oak boards, laminated them together, and >attached the WT device to it.... Thanks, Royce. That's exactly what I wanted to know. DaveT
