In a message dated 3/18/2003 12:00:04 PM Eastern Standard Time, "Greg Zachmann"
<[EMAIL PROTECTED]> writes:
>Hi Tedd,
Actually it was residual bend I
>would want to measure. >>
>>
Gregg, Get two vee blocks, one for each end of the shaft and put a dial indicator in
the center. When you rotate the shaft the indicator will read the amount of runout or
bend.
Frank
>>
>-----Original Message-----
>From: [EMAIL PROTECTED]
>[mailto:[EMAIL PROTECTED] Behalf Of Childers, Tedd A
>Sent: Tuesday, March 18, 2003 11:23 AM
>To: '[EMAIL PROTECTED]'
>Subject: RE: ShopTalk: Straightness finder
>
>
>Greg,
>
>The device Corey designed finds the residual bend in steel shafts (and
>snip
>
>
>
