I
agree, but I'd also add that if you have sufficient parallel tip section, you
can also do some tip trimming to get all three to match on the same flex
line. If you look at a shaft as being in three sections....a parallel tip
section, a tapered center section, and a parallel butt section, the objective is
to take a section from that overall length that has the flex that you want to
achieve. For a given shaft length, taking less tip trim (which implies
more butt trim) means a softer shaft, while taking more tip trim (which
implies less butt trim) results in a stiffer shaft.
Royce
-----Original Message-----In a message dated 4/13/2004 5:53:26 AM Pacific Daylight Time, [EMAIL PROTECTED] writes:
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]On Behalf Of [EMAIL PROTECTED]
Sent: Tuesday, April 13, 2004 10:13 PM
To: [EMAIL PROTECTED]
Subject: Re: ShopTalk: Conversion factors
Good idea...I purchased 3 Graffaloy Powerlite wood shafts on Ebay, 1 S, 1 R, and 1 A. I built the S shaft into a 1-wood and I want to match the A&R shafts on a 3&5 set, but the charts say I can only butt trim, is there any way to match these shafts, preferably as R flex?
The best way to do it would be to use the A on the 1, the R on the 3, and the S on the 5.
David
