I removed(drilled out) the broken shaft from the TM last night and LO and behold the hosel is 350 at the bottom and larger 1/2" down from the top so I can try and get the special ferrule (where from ?) or " McGiver" it by using a standard 350 ferrule that I have and shimming the top 1/2" of the hosel . what could i use for a really good shim that I could have lying around my shop or house?
Jeremy
[EMAIL PROTECTED] wrote:
In a message dated 10/21/04 10:52:02 AM Eastern Daylight Time, [EMAIL PROTECTED] writes:
Do I need a special ferule for A TM reshaft?
The ferrule inside diameter should match the outside diameter of the shaft AND the outside diameter of the ferrule should be larger (to allow for turning down) or match the outside diameter of the top of the hosel.. In addition some hosels have a larger inside diameter at the top of the hosel requiring an inset ferrule. Once the head has been removed you will have your answer. Within a specific manufacturer's line there is rarely any standardization.
