So, what your saying conflicts directly with what Dave Metcalf says and what Brooks says.. that the particle size does not vary. So who is right? You all have convincing arguments.
Jeff -----Original Message----- From: Marshall Dudley <[email protected]> To: [email protected] <[email protected]> Date: Thursday, December 02, 1999 11:37 PM Subject: Re: CS>Particle size >It is not difficult to prove. Take some clear CS and boil it and watch the >color change from clear to gold, to orange to red. It is well known fact that >the color reflects differences in particle size. This can be done without even >using a spectrophotometer. > >Marshall > >Jeff Gilman wrote: > >> Mark Metcalf of Silver Solutions says that its impossible to change the >> particle size. That the laws of electrochemistry prove that the particle >> size remains constant regardless of the voltage, temp of the water, etc. I >> would like to get this issue settled once and for all. Can anybody point me >> to any references which will prove or disprove this? >> >> Thanks, >> >> Jeff >> -----Original Message----- >> From: Katarina Wittich <[email protected]> >> To: [email protected] <[email protected]> >> Date: Tuesday, November 30, 1999 12:44 PM >> Subject: CS>Re: Bil, boiling water. >> >> >Hi Bil, >> >so , I have two questions. >> >Doesn't heating the water increase particle size? As the particles bump >> into >> >each other and agglomerate and make cs faster but bigger particles? >> > >> >And how do you boil water in a glass jar without it breaking? What kind of >> >jar? I looked for glass kettles in the store but didn't find anything. >> >Thanks, >> >katarina >> > >> > >> >> I have been making CS for some time. I started out >> >> with a 16 oz. jar and was told to use boiling hot >> >> distilled water and no salt to have the smallest particle >> >> size. >> >> >> >> Now I use a gallon jar. The distilled water I buy here >> >> in California always tests below 2 ppm. I boil the >> >> water in a very clean glass pot. If I use cold water the >> >> CS process takes forever. Also no matter how much >> >> I limit the current (as low as 2 mA) the cathode always >> >> gets very thick with sludge. This is my setup: >> >> >> >> One gallon glass jar (clean) >> >> Plastic lid >> >> 99.99% silver, 1" x 3.5" (wetted) >> >> Food grade stainless steel, 1" x 8" (wetted) >> >> Stainless steel bolts and nuts (on lid) >> >> Electrodes spaced 1/2" apart >> >> 30 volts DC >> >> >> >> Some of you guys are using 120 volts AC rectified and >> >> filtered to produce ~170 volts DC. How much current >> >> are you running? What is the advantage? >> >> >> >> Is it possible to make 5 or 10 ppm CS by the gallon >> >> without the sludge using low voltage? >> >> >> >> Thank you very much for your replies. >> >> >> >> Bil >> >> >> > >> > >> >-- >> >The silver-list is a moderated forum for discussion of colloidal silver. >> > >> >To join or quit silver-list or silver-digest send an e-mail message to: >> >[email protected] -or- [email protected] >> >with the word subscribe or unsubscribe in the SUBJECT line. >> > >> >To post, address your message to: [email protected] >> >Silver-list archive: http://escribe.com/health/thesilverlist/index.html >> >List maintainer: Mike Devour <[email protected]> >> > > > >
