On Wed, 1 Nov 2000 20:26:26 -0800, "GaryJanine" <[email protected]>
wrote:
>I had been making CS with 3-9volts and 2 silver wires, 1 qt. jar of
>distilled water. I ran this for about 2 hrs. and mostly got a gold colored
>solution with a metallic taste.
Sounds about right. Eight or ten oz would need about 30 to 45 minutes, so a
quart would probably take a couple hours. You may be going just a little longer
in time than you have to. Try backing off 15 minutes and see what happens.
Golden is OK, clear is better.
Do you get a Tyndall effect when shining a light beam through it?
> I recently started making it with 2 - 1oz. silver (.999 fine) ingots and
>ran it for 1 hr. (I thought because of the increase in silver mass it would
>take less time to make same quality cs. I have made 2 batches so far and
>both are almost clear with very little taste. I watched the new batches
>carefully and noticed quite a bit of yellowish matter (more so than with the
>wires) coming off the silver, also stirred it frequently. Does anyone have
>any ideas about this?
Nothing but silver goes in the water? I mean, not the connecting wires or clips?
Did you clean the bars of any surface oils or contaminants?
I would think you would see grey or black matter rather than gold.
I dunno, Ivan?
Chuck
Is the surface of a planet the right place for a developing technological
civilization?
--
The silver-list is a moderated forum for discussion of colloidal silver.
To join or quit silver-list or silver-digest send an e-mail message to:
[email protected] -or- [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.
To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>
