Thanks for the info. So, is the sea salt good, bad or indifferent? ----- Original Message ----- From: Marshall Dudley <[email protected]> To: <[email protected]> Sent: Sunday, August 25, 2002 8:48 PM Subject: Re: CS>Re: buying cs instead of making it...
> Barbara Liles wrote: > > > Sorry Marshall. I re-read my post and it confused me. Let me try again. > > > > What I meant to say is some generators I read about are using 3 Batteries > > rather than 2. > > > > When making CS are we trying to get equal charge from a negative silver wire > > and a positive silver wire? > > The difference between 2 and 3 batteries is simply 18 or 27 volts. The currents > at both electrodes will be the same, as per Norton analysis. That is current > travels in a loop, and is equal at all points in the loop. > > > > > > > Then, to make a good brew, does the solution need to be stirred? > > > > Most here report better results if the CS is stirred during making it. This can > be with a bubbler, a mechanical stirer, or even a slight heat source on one side > for convection stiring. > > > > > Also, does the distance between the two silver wires make a difference. > > > > Yes it does, but I don't have any data on that since I do not use the LVDC > method myself. > > > > > When I first started making mine, I was told that my spring water would work > > and didn't need the distilled water. I know it worked to some extent, but > > the more I read on the list, the more I realize that the minerals in natural > > spring water must have an effect on my finished product so I switched to > > distilled. > > That was a good decision. > > > > > > > The spring water produced a cloudy brew whereas the distilled water made it > > clear. > > The spring water probably had some salts in it, calcium chloride, calcium > carbonate, potassium or sodium chloride. These would react with any silver ions > as they come off the wire producting silver carbonate or silver chloride. Most > silver compounds have very low solubility, so they tend to make the water cloudy > until it settles out. > > > > > > > Also, since we are going back to Silver 101, when using sea salt which makes > > the brew yellow, is this an indicator of particle size? I know it makes it > > faster, but what is it making faster? > > > > It increases the conductivity, thus increasing current and the rate of silver > removal from the wire. > > > > > This leads me to wonder about IV use. Since sodium chloride IV solution is > > salty, does that change the structure of the CS. I generally use D5W > > thinking that the salt would change the structure. > > > > It seems that silver ions will quickly combine with the chlorine in NaCl and > form a cloudy solution with then settles out over time. I am not sure just what > happens if you put silver chloride directly into the blood. > > > > > Just learning so any information is helpful. I'm still back tracking the > > achieves attempting to not ask questions that you old timers have addressed > > before, but that is a slow process. > > We may be old timers, but we keep learning as well. I would NEVER have thought > that taking large amounts of HVAC CS would do what they did to my fingernails. > That is a new data point for me. > > Marshall > > > -- > The silver-list is a moderated forum for discussion of colloidal silver. > > Instructions for unsubscribing may be found at: http://silverlist.org > > To post, address your message to: [email protected] > > Silver-list archive: http://escribe.com/health/thesilverlist/index.html > > List maintainer: Mike Devour <[email protected]> > >
