> From: "[email protected]" <[email protected]>
> Date: Wed, 18 Sep 2002 14:40:10 -0700 (PDT)
> Subject: Re: CS>2nd batch not working?
Corbin writes:
> I just started making some new Distilled water, and am
> finding that I am still getting the 2-6 ppm whatever
> it is WITHOUT using charcol.
Why don't you try a commercial DW -- I get good
results with DW from Walgreens drugstore for $1:00
per gallon.
>I am now in the process
> of tyring another exp electrocution, to see if I can
> get my yellow water back.
Why not try for a CLEAR batch? If you are using
a generator with three 9 volt batteries you should
be able to get a clear product.
>It might also not be any
> contamination from the distiller, but the fact that I
> am running at room temp instead of chilled. My first
> batch was non-charchol chilled water. My guess is
> that the reaction rates are slowly thus making a
> better product?
WRONG.
>Some have suggested boiling the water
> then putting the elctrodes in. I did this once and
> alos got black water, but was not sure of the purity
> of the distilled water so I will have to re-test this
> method
Forget boiling - much too HOT
Try the next batch at about 100 degrees with distilled water.
It is hard to recommend any more since you haven't
supplied any info on the generator set up you are using
Keep on keeping on.
Jack
--
The silver-list is a moderated forum for discussion of colloidal silver.
Instructions for unsubscribing may be found at: http://silverlist.org
To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>
