############# What does stirring do to CS during a brew ?
Smitty On 11/22/06, Dan Nave <[email protected]> wrote:
Increasing the surface area of the electrodes would *decrease* the effective *resistance* between the electrodes which would *increase* the *current* between them, all other things being equal (electrode spacing, voltage, type and amount of water remaining the same in both examples). Hopefully, your power supply has the capacity to supply the increased current and your CS brewing would proceed at a faster rate. Moving the electrodes closer together will also increase the current. You may have to add stirring at some point if the currents get too high. Is that what you were asking about? Dan ________________________________ From: Peter M. Stellas [mailto:[email protected]] Sent: Wednesday, November 22, 2006 1:30 PM To: [email protected] Subject: CS>technical question My power supply generates 30 volts DC at 0.400 milliamps. If I were to substantially increase the surface area of the electrodes, would that alone serve to decrease the current between the then available electrode area?? Peter
-- The Silver List is a moderated forum for discussing Colloidal Silver. Instructions for unsubscribing are posted at: http://silverlist.org To post, address your message to: [email protected] Address Off-Topic messages to: [email protected] The Silver List and Off Topic List archives are currently down... List maintainer: Mike Devour <[email protected]>
