On Wed, 2009-03-11 at 15:53 +0530, Chaitra wrote:
> Shruthi Shashikanth wrote:
> > Consider 2 scenarios :
> > Scenraio1 :When phone 145 has voicemail permission.
> >
> > 1)Register 3 phones 145,146,147.
> > 2)Set user call forwarding for 145 such that:"at same time" forward to
> > 147 ring for 30 seconds.Click on apply.
> > 3)Default serial fork expiration = 20 sec
> > 4)From 146, dial 145. Do not answer the call.
> > Here Phone 145 and 147 start ringing simultaneously ("at the same
> > time").Phone 145 rings for a total of 20 seconds (Default serial fork
> > expiration) and stops, 147 rings for a total of 30 seconds, the call
> > then rolls to the voicemail of phone 145.
> >
> > The 302 moved temporarily shows the following:
> > Contact:
> > <sip:[email protected];x-sipX-nonat?ROUTE=%3Csip%3A176.25.10.204%3A5060%3Blr%3E>
> > Contact:<sip:[email protected];sipx-noroute=Voicemail?expires=30&X-sipX-Authidentity=%3Csip%3A145%40mercury.qantom.int%
> > 3Bsignature%3D49B743DD%253Aa8b9c3a0787681a6b4391389af4b25cf%3E&ROUTE=%3Csip%3A176.25.10.204%3A5060%3Blr%3E>;q=1.0
> > Contact:
> > <sip:[email protected]?route=%3csip%3a176.25.10.204%3a5060%3blr%3e>;q=0.1
> >
> > The above scenario works correctly.The expected behavior required is for
> > the scenario when 145 does not have voicemail permission as mentioned below.
> > Scenario 2: When 145 DOES NOT have voicemail permission.
> >
> > Steps:
> > 1)Set user call forwarding for 145 such that: "at same time" forward to
> > 147 ring for 30 seconds.Click on apply.
> > 2)Default serial fork expiration = 20 sec
> > 3)From 146, dial 145. Do not answer the call.
> > Here phone 145 and 147 start ringing simultaneously ("at the same time")
> > But Phone 145 rings for a total of 60 seconds. (is this the right
> > behavior?) 147 rings for a total of 30 seconds, upon no answer the call
> > gets disconnected on the caller.
> >
> > Should 145 ring for 60 seconds, since it does not have voicemail
> > permissions ? Is this the right behavior?
> >
> According to me this is the right behavior. If voicemail permission is
> disabled for 145, 145 would ring for 60 seconds and then send a 603
> decline (incase of Polycom). Default serial fork expiration time would
> be effective only if any sequential forking is involved. In this setup
> the calls are forwarded in parallel , also 145 does not have voicemail
> permissions.
I believe that's correct
_______________________________________________
sipx-dev mailing list
[email protected]
List Archive: http://list.sipfoundry.org/archive/sipx-dev
Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-dev
