On Thu, Jul 9, 2009 at 5:25 AM, Rene Pankratz<[email protected]> wrote: > I am using SipXecs 4.0.1. > > I already disabled all the settings in my X-Lite softphone as described in > the document. > But it seemed the settings did not work until complete restart of X-Lite. > Now everything works fine.
Please share your bluesip settings and any experiences. Please look at the configuration table on the wiki and post the relevant settings. Thanks Ranga > > 2009/7/9 Tony Graziano <[email protected]> >> >> What kind of phone are you using remotely? What kind of firewall? >> A lot of consumer firewalls need to have the ALG (Application Layer >> Gateway) for SIP turned off, though you may have to dig through the advanced >> settings to find it. If your remote phone is a softphone, you should make >> sure you have all the settings (local address/disable ice) configured as >> described below.. >> >> What version of sipxecs do you have installed? >> >> >>> Rene Pankratz <[email protected]> 07/09/09 5:10 AM >>> >> Thanks for your answer, i only set up the settings you described und went >> on >> the steps. >> There were only left the loopback and th local subnet the SipX and the >> phones are in in the internet calling settings. >> >> But still there is the voice related problem. >> When calling an internal phone the remote worker's phone is sent sdp with >> the internal address (behind NAT) of the called phone. So there is no way >> getting RTP into the office. >> >> René >> >> 2009/7/9 Tony Graziano <[email protected]> >> >> > I think you are misinterpreting the instructions. >> > On that page you simply define your local routed subnets. >> > Internet calling does not factor for remote worker setup except to >> > define >> > your internal subnets so that your system knows to accept those calls >> > instead of rejecting them for lack of authentication via the proxy. >> > Define >> > your subnets (not the one your remote worker is on since it is not >> > privately >> > routed) and go to the next step. >> > >> > >>> Rene Pankratz <[email protected]> 07/09/09 4:11 AM >>> >> > Hallo, >> > after successfully configuring a SIP Trunk with bluesip I wanted to add >> > support for remote workers on my SipX-installation (4.0.1-015823). >> > >> > I wanted to configure remote workers as described here: >> > >> > >> > http://sipx-wiki.calivia.com/index.php/Configuring_remote_workers_cheatsheet >> > >> > But when I navigate to System->Internet Calling I cannot select the SBC >> > that >> > is already configured for SIP Trunk. >> > >> > How can I select the existing or configure another internal SBC für >> > handling >> > remote workers? >> > >> > At this point remote clients can register, but RTP is handled incorrect >> > as >> > the SDP part shows the internal IPs of the phones in SipX's internal >> > network. >> > >> > Thanks in advance >> > René >> > </[email protected]> >> > >> </[email protected]></[email protected]> > > > _______________________________________________ > sipx-users mailing list [email protected] > List Archive: http://list.sipfoundry.org/archive/sipx-users > Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users > sipXecs IP PBX -- http://www.sipfoundry.org/ > -- M. Ranganathan _______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users sipXecs IP PBX -- http://www.sipfoundry.org/
