On Sun, 31 Oct 2004 17:42:09 -0000 "snorklersrus" <[EMAIL PROTECTED]> wrote:
> > > > I've connected my Orion Intelliscope to CDC using the 10/23/04 > Intelliscope driver written by Gary Carpenter. > > I can't figure if I'm supposed to do the star alignment with CDC or the > Intelliscope controller. I tried both, but CDC still says I haven't > aligned my scope. I've got it set up for 9216 ticks since the encoders > are 9216 steps. I've tried it with Device Status checked and > unchecked. My encoder configuration is Alt-Az, with encoder > initialization angle 90 degrees. I've checked the Form always visible > box. Port configuation is 9600 81N. Default settings on timeout, > interval timeout, red interval, > > Maybe I should set it back to its default of 2000 steps? It will > sometimes display RA/Dec ticks, but other times it doesn't. Nothing > happens when I click the "Init 90" degree box. The status box shows me > communicating fine, but not initialised and 90 degree vertical > initialisation not done, even though I just clicked on it. > > Does anyone have step-by=step instructions on how to get my > Intelliscope controller talking to CDC? Good to here there is a driver for this, I wonder is there a verions for the linux version? I've to the XT12 Orion w/ Intelliscope -- bruce ------------------------ Yahoo! Groups Sponsor --------------------~--> $9.95 domain names from Yahoo!. Register anything. http://us.click.yahoo.com/J8kdrA/y20IAA/yQLSAA/1.XolB/TM --------------------------------------------------------------------~-> To Post a message, send it to: [email protected] To Unsubscribe, send a blank message to: [EMAIL PROTECTED] Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/skychart-discussion/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
