Hi Anand,
No,when I explicitly invoke insmod rtl8139 ,in addition to the error message
already mentioned at boot time ,I get init_module : Device or resource
busy,(though the card is not being used ).So,if I try rmmod rtl8139,it
says module not loaded.
Please suggest me what to do
With Regards,
Sudhish
----- Original Message -----
From: Anand Kumria <[EMAIL PROTECTED]>
To: kiran babu <[EMAIL PROTECTED]>
Cc: <[EMAIL PROTECTED]>
Sent: Friday, April 13, 2001 4:39 PM
Subject: Re: [SLUG] delaying eth0 initialization
> On Fri, Apr 13, 2001 at 04:32:01PM +0530, kiran babu wrote:
> > Hi everybody,
> >
> > This is the problem Iam facing :
> >
> > At boot time the following message is displayed :
> >
> > Bringing up eth0 : insmod failed : Hint :insmod errors could be caused
by incorrect
> > module parameters ,including IRQ and I/O .
> > Delaying eth0 initialization.
> >
> > A few details :
> >
> > The NIC is from D-link with rtl8139 driver.
> > /proc/pci shows ethernet with IRQ 9 and I/O address 0xd800
> > It also shows Unknown vendor Unknown device(rev 16)
> > Vendor Id 1186 Device Id 1300
> >
> > ifconfig does not show eth0.
> > The module is available as a loadable kernel module,however,lsmod does
not show
> > the associated module i.e rtl8139.
>
> Does it work when you manually do an insmod and specify the correct
location?
>
> If so probably one of the module configuration files need to have the io
and
> irq settings updated.
>
> Anand
>
>
> --
> SLUG - Sydney Linux User Group Mailing List - http://slug.org.au/
> More Info: http://slug.org.au/lists/listinfo/slug
>
--
SLUG - Sydney Linux User Group Mailing List - http://slug.org.au/
More Info: http://slug.org.au/lists/listinfo/slug
