Very nice! I assume it doesn’t
matter if the Airpoints are on different frequencies, right?
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On
Behalf Of Vasu (sB Tech Team)
Sent: Saturday, June
07, 2003 11:33 PM
To: [EMAIL PROTECTED]
Subject: RE: [smartBridges]
Firmware?
Hi
Marlon,
1. Roaming
![]()
By
enabling the Roaming option, airBridge will associate with the Access Points
sharing the same ESSID and can switch in between them automatically.
o
Select Infrastructure
Mode
o
Uncheck "Select
>From Available Access Points" option
o
Enter Valid ESSID
o
Check Roaming option
o
Click Set Values button
Note
that the ESSID will be set to "000000000000"
In
this Mode, the airBridge can connect to any Access Point with the same ESSID,
based on signal strength and can switch in between them if one goes down. In
the above Fig. Access Points (Main and Standby) are shown. Both are ON at the
time and share same ESSID. airBridge is associated to Main airPoint-PRO. The
airBridge has specific settings. The ESSID is same as that of Access Point and
BSSID equal to "0000000000000". In case if the Main Access Point goes
down, airBridge will reassociate with the Standby Access Point. The switchover
time in normally upto 5 secs. This guarantees the internet connection to all
the PCs behind airBridge even if one Access Point goes down.
Vasu
-----Original Message-----
From:
[EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Marlon Schafer (509-982-2181)
Sent: Saturday, June 07, 2003
11:07 PM
To: '[EMAIL PROTECTED]'
Subject: Re: [smartBridges]
Firmware?
Tell me about the roaming option!
----- Original Message -----
Sent: Saturday,
June 07, 2003 7:57 AM
Subject: RE:
[smartBridges] Firmware?
Our latest release (5th
June 2003) version1.51 for the airBrigde is just an updated version from the
March release version. Using with the same firmware again with following
improvements.
- Roaming option added
- Over all improvements in GUI to
handle Tab order, Enter Key & ESC key
- PPPoE Support (using RASPPPoE Client)
- Firmware upgrade across the
subnets
- Can not login as Administrator
with user password
- Primary Port (renamed from
Primary DHCP Port)
Seeni, SB support
-----Original Message-----
From:
[EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of phantam
Sent: Saturday, June 07, 2003 1:54
PM
To: '[EMAIL PROTECTED]'
Subject: [smartBridges] Firmware?
Firmware?
Airbridge? AirPoint?
Whats up
with this or am I just completely dumb, you said new firmware for the units but
the 1.51 monitor has the 1.4 firmware it says
|
CD Release ver 1.51 (includes
firmware ver 0.01.04)
5 June 2003
|
|
CD Release ver 1.5 (includes
firmware ver 0.01.04)
3 March 2003
|
Ok so after
1 full month there are no firmware changes just new buttons? Am I missin
something here or am I just loosin my mind? Ok before I get flamed stop yellin
at me its just a question.
Chris
