BTW...I did not upgrade any of these units to the new BETA firmware. So...it's not that either.
As a matter of fact, I haven't done anything to these units. I bet that a manual "restore to factory default" by the client would allow me to log in again. But....being that the units are working still, I really don't want to bother the client. Sully -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of The Wirefree Network Sent: Saturday, July 19, 2003 11:11 PM To: [EMAIL PROTECTED] Subject: RE: [smartBridges] Cant log into units?? MORE INFO: Rebooting the devices with simpleNMS does NOT work. I still can not log into 75% of my units (aP, aPPo, aB, aBO). I used simpleDeploy to reflash the "bad" aPPo-CB units (aPPo's and aP's are the only ones I can still wirelessly use simpeDeploy on). Once I reflashed them with simpleDeploy, I was able to log in as normal with simpleMonitor. 1. simpleDeploy uses the ADMIN password. So...obviously, I know my passwords. So...please don't suggest bad password. 2. I have simpleNMS loaded with my ADMIN passwords as well, and I am able to see stats and perform reboots. Once again proving that I know all my passwords. 3. MRTG is polling the units every 5 minutes with the USER passwords. One last time proving that I know my passwords. So....why am I all of a sudden unable to log into 75% of my units (very old and very new units)?!?!?! Why does reflashing them with simpleDeploy fix the problem??? About 30 of my units are aB or aBo's, so I cant use simpleDeploy to fix the problem. Anyone have any suggestions??? Sully -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of The Wirefree Network Sent: Saturday, July 19, 2003 9:58 PM To: [EMAIL PROTECTED] Subject: [smartBridges] Cant log into units?? For some odd reason, I can not log into a lot of my units using simpleMonitor. I have tried both the admin and user passwords as well. To add to the oddness, simpleNMS is able to talk with all the units (obtaining their stats, etc). But when I choose MANAGE (which opens simpleMonitor--also using my ADMIN password), I get the "Can not read...check your password" crap. Same thing happens when I try to open it with simpleMonitor directly. More oddness....MRTG is polling the units just fine, obtaining their usage, RSSI and LQ...using the USER password. I am stumped. I don't know when this started...cause I don't normally log into the units unless there is a problem. I had one that wouldn't let me in today, so I tried all of them. To recap...I can not log into over half of my units (about 35 of the 45) using either the ADMIN or USER password What the heck I am doing wrong....duh....am I forgetting something really stupid??? Sully The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
