Dam, I wish I could find my old Electronics Engineering book from my college days.. ;-)
Kevin Summers KISTech Internet Services Inc. www.kistech.com > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] Behalf Of Tom Haynes > Sent: Tuesday, August 05, 2003 10:27 AM > To: [EMAIL PROTECTED] > Subject: RE: [smartBridges] AirPoint-Pro Outdoor > > > You can go 100 meters (max ethernet spec) but you MUST have a > 15-18vDC @ 1A > minimum for that length. If you have a volt meter you should read 5vdc or > more at the airPoint. If you don't read anything then you have a bad > connection somewhere. Even with a 12v power supply you should read around > 10v with no load and ~1v with the unit connected. Using 100 meters of Cat5 > 26awg wire with 18vdc power supply and unit running at full load > of .5A you > will only have 6v left at the end. > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] > On Behalf Of Coy Wadsworth > Sent: Tuesday, August 05, 2003 12:14 PM > To: [EMAIL PROTECTED] > Subject: RE: [smartBridges] AirPoint-Pro Outdoor > > > I would say it's a power issue over anything else. I guess it wouldn't > hurt to put new RJ45 ends on to see if that fixes your problem before > you go by the power supply. But 100 meters is just to far for 12V > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Rob Cleminson > Sent: Tuesday, August 05, 2003 11:11 AM > To: [EMAIL PROTECTED] > Subject: RE: [smartBridges] AirPoint-Pro Outdoor > > I can shorten the cable a bit if necessary but just want to see power up > there for now - > > Is 18V a MUST or could there be something else wrong? > > Cheers > > Rob > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Sam > Sent: 05 August 2003 18:07 > To: [EMAIL PROTECTED] > Subject: RE: [smartBridges] AirPoint-Pro Outdoor > > Make sure if you get one at Radio Shack that it outputs DC voltage and > not > AC. I bought one there without paying attention, and it was VAC. Also > you'll need to buy an adaptor to make sure it will fit into the > powershot. > (You should probably take the powershot with you to the store.) > > On Tue, 5 > Aug 2003, Coy Wadsworth wrote: > > > Correct me if I'm wrong but that is like 328 Feet. You should only > run > > CAT5 300 feet at the most and that's when your not running power over > > Ethernet. I would look for a 18V power supply. I think you can > purchse > > them at radio shack. > > > > -----Original Message----- > > From: [EMAIL PROTECTED] > > [mailto:[EMAIL PROTECTED] On Behalf Of Rob Cleminson > > Sent: Tuesday, August 05, 2003 10:57 AM > > To: [EMAIL PROTECTED] > > Subject: [smartBridges] AirPoint-Pro Outdoor > > > > Hi, > > > > I just purchased my first Airpoint Pro Outdoor - Powered it up fine on > > my desk. > > > > Just got down from installing on my tower - I have 100Metres of CAT5 > and > > now no power is arriving at the unit? > > > > Is this because I am using the standard 12V AC Adapter and because of > > the extra cable length now need 15V. There is a note in the booklet > > suggesting that this is best but I am not sure if it is a MUST > > > > Any advice? > > > > Regards > > > > Rob Cleminson > > > > > > The PART-15.ORG smartBridges Discussion List > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe > smartBridges <yournickname> > To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe > smartBridges) > Archives: http://archives.part-15.org > > The PART-15.ORG smartBridges Discussion List > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe > smartBridges <yournickname> > To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe > smartBridges) > Archives: http://archives.part-15.org > > The PART-15.ORG smartBridges Discussion List > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe > smartBridges <yournickname> > To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe > smartBridges) > Archives: http://archives.part-15.org > > The PART-15.ORG smartBridges Discussion List > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe > smartBridges <yournickname> > To Remove: mailto:[EMAIL PROTECTED] (in the body type > unsubscribe smartBridges) > Archives: http://archives.part-15.org The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
