RE: [smartBridges] AirPoint-Pro Outdoor

sBTech Thu, 14 Aug 2003 12:16:28 -0700

Hi Rob Cleminson,

An 18 V DC plug is an ideal and sufficient plug however you have to make sure that the polarity of the plug should as specified in the website.

http://www.smartbridges.com/new/products/ps.php

Few customers are using Motorola Canopy Powershot which is 24V and it is same pin as sB.

Also you can use the following powersupply, however you need to change the Pin polarity as stated in the specification.

Brand: Mouser

Model: 552-PSA-31U-180 [EMAIL PROTECTED]

To help you procure the correct power supply adapter, the specification of the power adapter is :-

Output Voltage Range	Regulated between 15V to 18V (max)
Current Ratings	1 Ampere
Type of Plug	Barrel Type
Plug Polarity	outer body = +ve, center = -ve
Diameter of plug	Inner Diameter of the plug = 2.5mm Outer Diameter of the plug = 5.5mm
Length of the plug	10mm or more

Thank you

Seeni, SB support

-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Rob Cleminson
Sent: Wednesday, August 06, 2003 12:57 AM
To: '[EMAIL PROTECTED]'
Subject: [smartBridges] AirPoint-Pro Outdoor

Hi,

I just purchased my first Airpoint Pro Outdoor – Powered it up fine on my desk.

Just got down from installing on my tower – I have 100Metres of CAT5 and now no power is arriving at the unit?

Is this because I am using the standard 12V AC Adapter and because of the extra cable length now need 15V. There is a note in the booklet suggesting that this is best but I am not sure if it is a MUST

Any advice?

Regards

Rob Cleminson

image001.gif
Description: Binary data

RE: [smartBridges] AirPoint-Pro Outdoor

Reply via email to