Mike Great reply We have been using the ethernet surge protectors by Canopy for about $40 from ECOmm We are using these at the ground, are you saying this protection should be at the radio on the tower or will they take this spike to ground and do you think this would be sufficient I guess it would surely keep surges from your switch and from going back to your backhaul
Thanks Joe K -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Mike Brownson Sent: Sunday, August 10, 2003 9:34 PM To: [EMAIL PROTECTED] Subject: RE: [smartBridges] AP Indoor Years ago I used to do some lightning protection consulting and seminars for protecting Radio sites. One common misconception is that a shielded cable will keep the surge energy off the conductors inside. WRONG! Years ago the folks at PolyPhaser did some testing by applying a 10,000 amp surge to the shield of a cable. they measured what was at the end and found that half of the surge energy was transfered to the inner conductors. The small wonder of capacitance that transfers energy between parallel plates (or wires in this case). Still need an ethernet protector at the ground, shielded or not. Mike B > Chris > Just as important > We have been waiting on word hopeing they would rework the case of all > the radios > We don't have that many radios in the field testing > We lost one on a 50' tower, the lightning came in on the 50' piece of > non shielded cat 5 that was attached to the radio > We have two radios we have had to reset after a storm, suspect static > voltages in the air, no shielding > > They could easiely do away with the 6" piece of non shielded cat 5 > hanging down from the radio and put the > jack inside the radio with a screw in umg that tightens up on the cat 5, > they could spray the > cases with metalic paint > > I don't know how much it would take, not much I would think, they need > to increase the power to at least 100mw > I was told not to use amps, so far we haven't, but sometimes I think we > need to > >>From the best we could tell, we had one aBO disassociating, but the new > software fixed that > > Joe K > > > > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] Behalf Of Chris Chance > Sent: Saturday, August 09, 2003 12:14 AM > To: '[EMAIL PROTECTED]' > Subject: RE: [smartBridges] AP Indoor > > > So does this mean we are actually going to get the ABI link values for > the > clients FINALLY? I mean I recall asking this like 3 months ago J WOOHOOO > I CAN BUY MORE ABI's!!!!! MORE SMALL WIPOPS HERE I COME! > > > > Chris > > > > > -------------------------------------------------------------------------- -- > -- > > From: Earl Campbell [mailto:[EMAIL PROTECTED] > Sent: Friday, July 18, 2003 4:04 PM > To: [EMAIL PROTECTED] > > > > The bank would not cash it cause they said it was too big for > their > machine...and the cancled stamp they have was too small ! > > Earl > > > > > > -------Original Message------- > > > > From: [EMAIL PROTECTED] > > Date: Friday, August 08, 2003 02:25:55 PM > > To: [EMAIL PROTECTED] > > Subject: RE: [smartBridges] AP Indoor > > > > Nice check! How does it fit in your wallet? > > seriously, though, I couldn't find a link to show who you need > to > contact to get a grant like that. Any help? I'd like to get a big > check like that too! (and I don't mean size) > > > > On Fri, 2003-07-18 at 15:47, Earl Campbell wrote: > > > > > > See my web site http://www.uphi.net and click on grant. > Earl UpHi.net > > -------Original Message------- > > From: [EMAIL PROTECTED] > Date: Friday, August 08, 2003 02:10:29 PM > To: [EMAIL PROTECTED] > Subject: RE: [smartBridges] AP Indoor > > Hi Earl and Scott, > > If you don't mind, would either of you forward the > information > to me, too? > > Thanks! > Sevak > > On Fri, 2003-08-08 at 13:06, Scott Damron wrote: > Hey Earl, > > Could you contact me off list concerning the grant you > were > awarded? I just would like some info from someone who has actually been > awarded the money. > > Thanks, > > Scott > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Earl Campbell > Sent: Friday, July 18, 2003 10:04 AM > To: [EMAIL PROTECTED] > Subject: RE: [smartBridges] AP Indoor > > > > > > > > > > > > I have a piece of software I cant afford to buy yet > and > the demo is time limited. I keep resetting the date to make the software > demo work. When I buy the software, which I'm gonna do when I get the > money, the date and time will be correct. Till then....my own little > time warp ! > Earl - UpHi.net > BTW - haven't seen one red cent of the grant money > yet. > But we did get the legal papers 8-7-03 to fill out and send back. > Woh...ya wouldn't believe all the restrictions on the spending of this > money! Not to complain... it is a half million dollars any way ya look > at it. > > > -------Original Message------- > > From: [EMAIL PROTECTED] > Date: Friday, August 08, 2003 11:25:05 AM > To: [EMAIL PROTECTED] > Subject: RE: [smartBridges] AP Indoor > > He is in New Mexico, you never know what might be > going > on out there!!! > > Scott > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Kevin Proctor > Sent: Friday, August 08, 2003 9:50 AM > To: [EMAIL PROTECTED] > Subject: Re: [smartBridges] AP Indoor > > > I just thought Earl was operating in his own little > time > warp. :) > > Kevin > > Zathras' Lackey wrote: > Earl, > > Either your mail is taking an incredibly long time > to > hit the list or you need to reset the date on your computer. > > > > > On Friday, Jul 18, 2003, at 11:22 US/Central, Earl > Campbell wrote: > > When can we expect new firmware for the Air Point > Indoor units. Its a pain not to see signal strength in SimpleNMS for Air > Point Indoor units in the AP mode. > Earl - UpHi.net > > > > > > -- Kevin B. ProctorCustomer ServiceInternet SalesElectro-Comm > Distributing Inc.5015 Paris St.Denver, CO > 80239+1-800-525-0173+1-303-371-8182+1-303-371-8158 FAX+1-800-423-8018 > [EMAIL PROTECTED] PART-15.ORG smartBridges Discussion List To > Join: mailto:[EMAIL PROTECTED] (in the body type subscribe > smartBridges To Remove: mailto:[EMAIL PROTECTED] (in the body type > unsubscribe smartBridges) Archives: http://archives.part-15.org > > > > > > > > > > > > > > > > > > > ____________________________________________________ > IncrediMail - Email has finally evolved - Click Here > > > > > > > > > > > > > > > ____________________________________________________ > IncrediMail - Email has finally evolved - Click Here > > > > > > > > > > > ____________________________________________________ > IncrediMail - Email has finally evolved - Click Here Mike Brownson Electro-comm Distributing 5015 Paris St, Denver, CO 80239 (303) 371-8182 (800) 525-0173 The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
