In this case, we use just the crossover cable.
-------Original Message------- From: [EMAIL PROTECTED] Date: 18. 11. 2003 12:33:35 To: [EMAIL PROTECTED] Subject: [smartBridges] Crossover Cable Instead Of Hub/Switch At Relay Site I am using two aPPO's, connected using a Netgear 10Mps hub located in a dairy of a local farmer, to relay a signal around a hill. After reading the posts on the pros and cons of using a switch when connecting 2 radios together, would an alternative be to use a crossover cable and two male-male RJ45 connectors to join the two aPPO's directly? Is anyone using this at the moment? I'm going down to the site later this week to test it so will post my results back as and when. The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
