I had to do something similar in 2017 a while ago. You have to attach it to a path via the constrain panel ( constrain > motion paths > attach to motion path ), and then "....> flow motion path".
Like Joseph already mentioned, Maya then creates a lattice deformer that deforms the mesh along the path. - Ronald On 8/22/2017 15:39, Morten Bartholdy wrote: > I am on Maya 2016 ext1, and no Curve Warp :( > > We are installing Maya 2018 tomorrow, so no biggie. > Thanks. > > Morten > > > > > > Den 22. august 2017 klokken 15:32 skrev Rob Wuijster <[email protected]>: > > Just to add, pretty sure this was added in one of the later Extension > packs of Maya 2016. > It always amazes me how basic functionality like this is often not found > in Maya. > > Rob > > \/-------------\/----------------\/ > > On 22-8-2017 15:19, Ponthieux, Joseph G. (LARC-E1A)[LITES II] wrote: >> Maya has a command called Curve Warp in the Deform menu. It was introduced >> in Maya 2016 I think. Its fairly similar to SI's Deform by Curve. >> >> Joey >> >> -----Original Message----- >> From: [email protected] >> [[email protected]] On Behalf Of Morten Bartholdy >> Sent: Tuesday, August 22, 2017 9:09 AM >> To: Userlist, Softimage <[email protected]> >> Subject: Otish - is there a Maya equivalent of XSI's Deform by Curve? >> >> This place is still the best to ask questions like this, because people here >> understand, so please bear with me. >> >> I am looking for a Maya equivalent to XSI's Deform by Curve, but have found >> nothing like it. How do people do similar stuff in Maya? >> >> Thanks! >> >> Morten >> ------ >> Softimage Mailing List. >> To unsubscribe, send a mail to [email protected] with >> "unsubscribe" in the subject, and reply to confirm. >> >> ------ >> Softimage Mailing List. >> To unsubscribe, send a mail to [email protected] with >> "unsubscribe" in the subject, and reply to confirm. > ------ > Softimage Mailing List. > To unsubscribe, send a mail to [email protected] with > "unsubscribe" in the subject, and reply to confirm. > ------ > Softimage Mailing List. > To unsubscribe, send a mail to [email protected] with > "unsubscribe" in the subject, and reply to confirm. > ------ Softimage Mailing List. To unsubscribe, send a mail to [email protected] with "unsubscribe" in the subject, and reply to confirm.
