My bad. See
Jesper’s post.
I did not see that
you are using the VPN client.
I need to where my
glasses more.
What I posted
applies to unit to unit VPN.
John Tolmachoff
MCSE, CSSA
IT Manager, Network
Engineer
RelianceSoft,
Inc.
Fullerton,
CA
92835
www.reliancesoft.com
-----Original
Message-----
From:
[EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of Lance Loudan @
Benedict
Sent:
Tuesday, December 17,
2002 6:33
AM
To: '[EMAIL PROTECTED]'
Subject: RE: [SonicWALL]- Problem
forwarding packets
OK, I
have done that, my question is what is Spoke 1 is the VPN client setup in
Advanced mode. Do I need to setup another connection with the different
subnet on it. I am asking this because I tried this and it still is not
working. Do I also have to add the VPN internal IP address to Spoke
2.
-----Original
Message-----
From: John
Tolmachoff [mailto:[EMAIL PROTECTED]]
Sent: Monday, December
16, 2002 4:13
PM
To: [EMAIL PROTECTED]
Subject: RE: [SonicWALL]- Problem
forwarding packets
On
each "spoke" of the wheel, you have to define the other remote networks
(other spokes) under the networks listed in the SA properties
page.
Example:
Hub
network is 10.0.0.0/24
Spoke1 is
10.0.1.0/24
Spoke2 is
10.0.2.0/24
Spoke3 is
10.0.3.0/24
You
want Spoke 1 to have access to Spoke2.
On
the SA properties of Spoke 1, you have a destination network specified of
10.0.0.0/24
You
need to add a specified destination network of
10.0.2.0/24.
Now,
the Sonicwall will know that anything destined for 10.0.2.0/24 is to be sent
through the VPN to the hub Sonicwall, which will then forward it via the
appropriate SA to that network.
John
Tolmachoff MCSE, CSSA
IT
Manager, Network Engineer
RelianceSoft,
Inc.
Fullerton,
CA
92835
www.reliancesoft.com
-----Original
Message-----
From:
[EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of Lance Loudan @
Benedict
Sent:
Monday, December 16,
2002 11:54
AM
To: SonicWall User Forum
(E-mail)
Subject:
[SonicWALL]- Problem forwarding packets
I
have set up my VPN client as set forth in the advance instructions supplied
from Sonicwall. I have that working fine and can connect to the
firewall, my problem is that it is not forwarding to remote VPNs. Do I
need to setup a client for each new subnet and route it through the same
firewall. I guess my question is what tells the firewall to route the
packets. I have checked the route table and the remote VPN are not
listed in it but I have SAs setup for all of them. Do I still need to
add them to the routing table? The routes that I did add to the
routing table are still not working either. I could use some help
please.
